Advertisement
WARNING:
THE REMOTE WALL MOUNT WILL AUTOMATICALLY SWITCH OFF THE GAS Fireplace,
AGP Pellet Stove or GAS Insert WHEN THE BATTERIES IN THE REMOTE WALL MOUNT IS LOW.
2.0 OPERATION INSTRUCTIONS:
2.1 Wall Mount Transmitter Operation
The Thermostat Wall Wireless AGP Remote Control has 3 operating modes. They are: Manual, Auto and
Timer. Use the Up and Down buttons to set the target temperature between 45
o
32
C.
see
Figure 3
A. Settings :
1 Press and hold clock button for about 2 seconds.
2 The hour display will flash. Use the Up and Down buttons to set the hour.
3 Press the clock button again and the minute display will flash. Use the Up and Down buttons to set the
minutes.
4 Press the clock button again and the oF or oC display will flash. Use the Up and Down button to select the
Remote Transmitter to display temperature in oF or oC.
5 Press the clock button again to exit setting.
Figure 3
see
Figure 4
B. Manual Mode:
1 Press the Manual On/Off button once to light the GAS Fireplace, AGP Pellet Stove or GAS Insert. Push the
button again to turn it off.
2 In Manual mode the Remote Transmitter will not turn the GAS Fireplace, AGP Pellet Stove or GAS Insert off
even if the room temperature exceeds the target temperature.
3 The GAS Fireplace, AGP Pellet Stove or GAS Insert will automatic turn off after 6 hours.
Figure 4
"CLOCK"
button
Page 2 of 6
o
o
F and 90
F, or 8
Hour and minute
Display
Fahrenheit or
Celsius display
"UP" and "DOWN"
buttons
Manual button
o
C and
Advertisement
