Advertisement
see
Figure 5
C. Auto Mode:
1 Set the desired target temperature.
2 Press the Auto On/Off button once to activate the Auto mode. In Auto Mode the Remote Transmitter will
automatically turn on the GAS Fireplace, AGP Pellet Stove or GAS Insert when the room temperature is
below the target temperature and turn off the GAS Fireplace, AGP Pellet Stove or GAS Insert when the
room temperature is above the target temperature.
3 Press Auto On/Off button or Manual On/Off buttons to turn off the GAS Fireplace, AGP Pellet Stove or
GAS Insert (if it is already on) and exit Auto Mode.WARNING: IT TAKES SOME TIME FOR THE
RECEIVER TO RESPOND TO THE TRANSMITTER.DO NOT PRESS THE MANUALOR AUTO
ON/OFF BUTTONS MORE THAN ONCE WITHIN 2 SECONDS FOR CORRECT OPERATION.
Figure 5
see
Figure 6
D. Timer Mode:
1 You can set the timer to the length of time you want the GAS Fireplace, AGP Pellet Stove or GAS Insert to
operate (1 to 120 minutes).
2 Press the "TIMER" button once. The Timer display "----" will blink.
3 Press the Up and Down buttons to set the timer. The LCD will display the time chosen.
4 The timer setting can be cancelled at any time by press and hold the "TIMER" button.
5 Press Manual or Auto On/Off button to turn on the GAS Fireplace, AGP Pellet Stove or GAS Insert.
6 The GAS Fireplace, AGP Pellet Stove or GAS Insert will turn off at the end of the timer setting.
Figure 6
E. Child-Proof Function :
1 There is a CHILD-PROOF switch at the back of the Remote Transmitter.
2 Slide the CHILD-PROOF switch to position marked C/P to activate the CHILD-PROOF function and the
child-proof function icon will appear on the LCD.
3 In CHILD-PROOF the Remote Transmitter will not operate the Remote Receiver until the "child-proof"
code is used or the switch is returned to the other position.
4 Press the Up and Down buttons in the following sequence: Up-Down-Down-Up-Down, within 2seconds,
button function will be temporarily restored, the child-proof function icon will disappear from the LCD.
5 If no button is pressed within 2 minutes, the Remote Transmitter will return to the Child-Proof function and
the child-proof function icon will reappear on the LCD until the Child-Proof switch is slide back to the
other position.
see
Figure 7
Page 3 of 6
Set temperature
Adjust temperature
Control
1. Press the "TIMER" button the "---"
will start to flash.
2. Use the "UP" and "DOWN" buttons
to set the Time.
3. Press Manual or Auto On/Off
buttons to start the timer.
Advertisement
