Advertisement
1.2 Installing the Receiver for Gas Fireplace or Insert Wall Mount
1 Make sure the slide switch on the Remote Receiver is at the OFF position.
2 Gas Appliance Receiver Wire Installation (See Figure 1)
We recommend the receiver wires to be installed in a parallel circuit with the on/off switch (switch must
be in "OFF" position for remote to work). See the directions below for this type of installation..
Remove the
wires from the
on/off switch.
Back of
on/off switch
3 Installing the Remote Receiver to a Wall Mount:
- Secure the Remote Receiver to the wall mount.
- Use the screws provided to secure the face plate to the Remote Receiver. See Figure 2.
4 Put the switch cap to the slide switch.
5 Slide the battery compartment into the Remote Receiver. See Figure 3.
Installation of the
Receiver to a
Junction Box
BA T.L OW
1.3 Installing the Remote wall mount Transmitter
1 Install the Wall Mount bracket horizontally onto the wall using the screws provided. See figure 4.
2 Slide the Wall Mount Transmitter onto the Wall Mount bracket as shown is figure 5.
Attach the wires removed in
step "a" to the "Y" jumper wires
and attach the jumpers to the
on/off switch (orientation does
not matter).
"Y" Jumper
Wires
Figure 2
figure 4
AM
TIMER
ROOM TEMP
figure 5
Page 3 of 3
Attach the receiver wires to
the "Y" jumper wires
(orientation does not matter).
BA T.L OW
Figure 3
SET TEMP
F
Receiver
Wires
Figure 1
OF F
RE MO
TE ON
Advertisement
