Replacing The Battery - IBM IntelliStation E Pro Hardware Maintenance Manual

Event ID Type
19 Informational
20 Informational
21 Warning

Replacing the battery

When replacing the battery, you must replace it with a lithium battery of the same
type from the same manufacturer. To avoid possible danger, read and follow the
information in "Safety information" on page 129.
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure the system and reset the
Complete the following steps to replace the battery:
1. Follow any special handling and installation instructions supplied with the
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Complete the following steps to remove the battery:
4. Complete the following steps to insert the new battery:
Description
Explanation: Team nn. Preferred primary adapter took over.
Action: None.
Explanation: Team nn. Preferred secondary adapter took over.
Action: None.
Explanation: Team nn. Primary adapter does not sense any probes.
Possible reason: partitioned Team.
Action: Make sure the cables of the adapter team are connected to the
same LAN segment. Reconfigure the team if necessary.
system date and time.
replacement battery.
and power cords; then remove the computer cover.
a. Use one fingernail to press the top of the battery clip away from the battery.
The battery pops up when released.
b. Use your thumb and index finger to lift the battery from the socket.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
39
Diagnostics