IBM IntelliStation E Pro Hardware Maintenance Manual page 40

10. Replace the boot block jumper to pins 1 and 2.
11. Replace any adapters that were removed.
12. Replace the cover (see "Replacing the cover of the 6216" on page 55 or
13. Turn on the computer to restart the operating system.
30
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
3. Locate the boot block jumper (JP6) on the system board, removing any
adapters that impede access to the jumper.
Microprocessor
and fan
Rear fan
connector
AGP
PCI
connector 1
PCI
connector 2
Internal
speaker
PCI
connector 3
4. Move the jumper from pins 1 and 2 to pins 2 and 3.
5. Replace any adapters that were removed and replace the cover (see
"Replacing the cover of the 6216" on page 55 or "Replacing the cover of the
6226" on page 72). Reconnect the power cords for the computer and monitor
to electrical outlets.
6. Insert the flash diskette (see Note at the beginning of this procedure) into drive
A, and turn on the computer and monitor.
Note: No image will be displayed on the monitor while the flash update
diskette is running. This is normal.
7. After the update session is completed, remove the diskette from the diskette
drive, and turn off the computer and monitor.
8. Unplug all power cords from electrical outlets, and remove the cover.
9. Remove any adapters that impede access to the boot block jumper (JP6).
"Replacing the cover of the 6226" on page 72), and reconnect all cables that
were disconnected.
Microprocessor
DIMM
fan connector
connector 1
(CN3)
Boot block
Battery
jumper (JP6)
DIMM
connector 2
System fan
connector 1
(CN2)
SCSI LED
connector
Password
check
jumper
(JP1)
CMOS
clear
jumper
(JP3)
®
Wake on LAN
connector