IBM IntelliStation E Pro Hardware Maintenance Manual page 28

Setting the password check jumper (JP1)
The following illustration shows the location of the password check jumper (JP1) on
the system board.
Rear fan
connector
AGP
PCI
connector 1
PCI
connector 2
Internal
speaker
PCI
connector 3
Complete the following steps to set the password check jumper (JP1):
1. Review "Safety information" on page 129.
2. Turn off the computer and peripheral devices and disconnect all external cables
3. Move the jumper from pins 1 and 2 to pins 2 and 3. This clears the user
4. Connect the computer to a power source, keyboard, monitor, and mouse.
5. Turn on the computer.
You can now start the Configuration/Setup Utility program and either delete the old
password or set a new user password.
18
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
Microprocessor Microprocessor
and fan fan connector
(CN3)
and power cords; then, remove the cover (see "Removing the cover of the
6216" on page 45).
password for one boot cycle.
Note: You can now start the computer one time without having to use the user
password, but if you do not use the Configuration/Setup Utility program
to change or delete the password, the next time you start the computer,
the original user password will be reinstated.
DIMM DIMM
connector 1 connector 2
Boot block Battery
jumper (JP6)
System fan
connector 1
(CN2)
SCSI LED
connector
Password
check
jumper
(JP1)
CMOS
clear
jumper
(JP3)
®
Wake on LAN
connector