Fujitsu Primergy TX120 User Manual page 205

Item
System Password Mode
System Password Lock
System Load
Setup Prompt
Virus Warning
Diskette Write
Flash Write
table: Items on the Security Menu
Setting
• System (Initial value)
• Keyboard
• Standard
• WOL Skip (Initial value)
• Standard (Initial value)
• Diskette/CDROM Lock
• Disabled
• Enabled (Initial value)
Disabled (Unchangeable)
• Disabled
• Enabled (Initial value)
• Disabled
• Enabled (Initial value)
PRIMERGY TX120 User's Guide
Description
Sets the password entering for system start-up. You
can set this item only when [System Password] is
specified.
• System
The password entry screen is displayed when the
system is started. You can unlock the system
with the password.
• Keyboard
A password is not required. Keyboard and mouse
are locked to prevent the operation. You can
unlock the system by entering the password on
the keyboard and pressing the [Enter] key.
Sets whether or not to skip entering the password
when the system is started with Wakeup on LAN.
You can set this item only when [System Password
Mode] is set to [System].
Sets whether to enable or disable system startup
from a floppy disk or CD-ROM.
Sets whether or not to display a setup message
"<F2>BIOS Setup/<F12>BOOT Menu" on the
[POST] window during system startup.
Sets whether or not to check the boot sector of the
hard disk drive after the previous system startup. If
the boot sector is changed without a clear reason, it
is necessary to scan the system for computer viruses
with a virus detection program.
Sets whether or not to allow writing on a floppy
disk.
Sets whether or not to allow writing on the BIOS
Flash ROM.
8
205