City Safe Drive; Start/Stop - KODA Citigo Owner's Manual

›
The temperature of the vehicle battery is not too low or too high.
›
There is sufficient pressure in the braking system.
›
The difference between the outdoor- and the set temperature in the interior is
not too great.
›
The vehicle speed since the last time the engine was switched off was greater
than 3 km/h.
›
The front wheels are not turned excessively (the steering angle is less than 3/4
of a steering wheel revolution).
The automatic re-start (start phase) takes place in each of the following
interventions:
›
The clutch is depressed.
›
The max./min. temperature is set.
›
The defrost function for the windscreen is switched on.
›
A high blower stage has been selected.
›
The START STOP button is pressed.
The automatic re-start takes place in each of the following situations, without
intervention from the driver:
›
The vehicle moves at a speed of more than 3 km/h.
›
The difference between the outdoor- and the set temperature in the interior is
too great.
›
The charge state of the vehicle battery is not sufficient.
›
There is insufficient pressure in the braking system.
If the driver's seat belt is removed for more than 30 seconds during stop mode or
the driver's door opened, the engine must be started manually using the key.

City Safe Drive


Introduction
Fig. 82 Laser sensor/detection range
This chapter contains information on the following subjects:
Switching the City Safe Drive on and off
Laser sensor
Special driving situations
The City Safe Drive system uses the laser sensor
about the traffic situation in front of the vehicle at a range of around 10 metres (11

yards) » Fig. 82 –  in a vehicle speed range of 5 - -30 km/h (3 - -19 mph).
If the driver does not respond to an imminent collision, the City Safe Drive system
can automatically apply the brakes to the vehicle to prevent a possible collision.
If the City Safe Drive system is currently slowing the vehicle down automatically,
the warning light will flash  quickly.
Automatic braking interventions can be terminated by pressing the clutch, accel-
erator or by moving the steering wheel.
If the City Safe Drive system is not currently available, or if there is a system fault,
the warning light will flash  slowly.
The following conditions cause the City Safe Drive system to become not availa-
ble.
›
Taking bends tightly.
›
When fully pressing down the accelerator pedal.
›
When the City Safe Drive system function is switched off/faulty.
›
When the laser sensor is dirty, concealed or has overheated
84
85
85
» Fig. 82 –  to take readings
» page 85.

83
Assist systems