Information On Braking - KODA Citigo Owner's Manual

CAUTION
Observe the recommendations on the new brake pads
■
Never let the brakes slip with light pressure on the pedal if braking is not neces-
■
sary. This causes the brakes to overheat and can also result in a longer braking
distance and excessive wear.
Note
If the brakes are applied in full and the control unit for the braking system con-
■
siders the situation to be dangerous for the following traffic, the brake light
flashes automatically. After the speed was reduced below around 10 km/h or the
vehicle was stopped, the brake light stops flashing and the hazard warning light
system switches on. The hazard warning light system is switched off automatical-
ly after accelerating or driving off again.
Before negotiating a steep downhill section, reduce the speed, shift down into
■
the next lower gear (manual gearbox) or select a lower drive position (automatic
gearbox). As a result, the braking effect of the engine will be used, reducing the
load on the brakes. Any additional braking should be completed intermittently,
not continuously.

Information on braking


First read and observe the introductory information and safety warn-
ings on page 65.
Wear-and-tear
The wear of the brake pads is dependent on the operating conditions and driving
style. The brake pads wear more quickly if a lot of journeys are completed in
towns and over short distances or if a very sporty style of driving is adopted. Un-
der these severe conditions, the thickness of the brake pads must be checked by
a specialist garage before the next service appointment.
Wet roads or road salt
The performance of the brakes can be delayed as the brake discs and brake pads
may be moist or have a coating of ice or layer of salt on them in winter. The
brakes are cleaned and dried by applying the brakes several times.
66
Driving
Corrosion
Corrosion on the brake discs and dirt on the bake pads occur if the vehicle has
been parked for a long period and if you do not make much use of the braking
» page 71.
system. If the brake system is not used much or if there is corrosion on the sur-
face, we recommend cleaning the brake discs by firmly applying the brakes from a
high speed.
Faults in the brake surface
If it is found that the braking distance has suddenly become longer and that the
brake pedal can be depressed further, the brake system may be faulty. Visit a
specialist garage immediately and adjust your style of driving appropriately as you
will not know the exact extent of the damage.
Low brake fluid level
An insufficient level of brake fluid may result in problems in the brake system. The
level of the brake fluid is monitored electronically
Brake booster
The brake booster increases the pressure generated with the brake pedal. The
brake booster only operates when the engine is running.

Handbrake

Apply
›
Pull the handbrake lever firmly upwards.
Loosening
›
Pull the handbrake lever up slightly and at the same time push in the locking
button
›
Move the lever right down while pressing the lock button.
First read and observe the introductory information and safety warn-
ings on page 65.
» Fig. 70.
» page 14, Braking system.
Fig. 70
Centre console: Handbrake

