KODA Citigo Owner's Manual page 142

›
Stow and attach the replaced wheel in the spare wheel compartment using a
special screw » page 134.
›
Stow the vehicle tool kit in the space provided.
›
Check the tyre pressure on the installed spare wheel as soon as possible.
›
Have the tightening torque of the wheel bolts checked with a torque wrench
as soon as possible.
›
Replace the damaged wheel or consult a specialist garage about repair options.
WARNING
If it is determined that the wheel bolts are corroded and difficult to turn
■
when changing the wheel, the bolts must be replaced before checking the
tightening torque.
Drive cautiously and only at a moderate speed until the tightening torque
■
has been checked.
Loosening/tightening wheel bolts
Fig. 116 Changing a wheel: Undoing the wheel bolts/installation location of
the anti-theft wheel bolt

First read and observe the introductory information and safety warn-
ings on page 138.
Loosening
›
Push the wheel wrench onto the wheel bolt up to the stop
›
Grasp the end of the wrench and turn the bolt about one turn to the
left » Fig. 116 - .
1)
Use the appropriate adapter for undoing and tightening the anti-theft wheel bolts
140
Do-it-yourself
Tightening
›
Push the wheel wrench onto the wheel bolt up to the stop
›
Grasp the end of the wrench and turn the bolt to the right until it is tight.
For a wheel with full wheel trim, the anti-theft wheel bolt must be screwed in at
position
be installed.
WARNING
Undo the wheel bolts only a little (about one turn) provided that the vehicle
has not yet been jacked up. Otherwise the wheel could come off and fall down
– risk of injury!
Note

If it proves difficult to undo the bolts, carefully apply pressure to the end of the
wrench with your foot. Keep hold of the vehicle when doing so, and make sure
you keep your footing.
1) .
» page 141.
» Fig. 116 opposite the valve . Otherwise the full wheel trim cannot
2 1
.
1)
