Lights And Visibility; Headlight Beam Adjustment; Function Day Light (Daytime Running Lights); Turn Signal And Main Beam Light - KODA Citigo Owner's Manual

Headlight beam adjustment


First read and observe the introductory information and safety warn-
ings on page 31.
Turning the rotary switch » Fig. 23
headlight beam adjustment, thereby shortening the beam of light.
Settings
The positions correspond approximately to the following car load.
Front seats occupied, luggage compartment empty.
-
All seats occupied, luggage compartment empty.
1
2 All seats occupied, luggage compartment loaded.
Driver seat occupied, luggage compartment loaded.
3
WARNING
Always adjust the headlight range adjustment in such a way that:
it does not dazzle other road users, especially oncoming traffic;
■
and the range is sufficient for safe driving.
■
Note
We recommend you adjust the headlight beam when the low beam is switched
on.
32
Using the system
Fig. 23
Dash panel: Lights and visibility
from position to gradually activates the
- 3

Function DAY LIGHT (daytime running lights)


First read and observe the introductory information and safety warn-
ings on page 31.
Switching on daytime running lights
›
Turn the light switch to position 0
When the daytime running lights are switched on, the lighting for the instrument
cluster is switched off, and the parking lights and the license plate light do not
light up.

Turn signal and main beam light


First read and observe the introductory information and safety warn-
ings on page 31.
The lever is also used to operate the parking light and the headlight flasher.
Right and left turn signal light
 
›
Push the lever » Fig. 24 upwards
›
If you only wish to flash three times (the "convenience turn signal"), briefly push
the lever to the upper or lower pressure point and release again.
›
Turn signal for changing lanes – to only flash briefly, move the lever up or down
to the pressure point and hold it in this position.

Main beam

›
Switch on the low beam » page
›
Press the lever » Fig. 24 in the direction of arrow
›
The main beam is switched off by pulling the lever into the initial position in the
direction of arrow .
D
» Fig. 22 on page 31.
Fig. 24
Operating lever: Turn signal and
main beam operation
or downwards .
A B
31.
.
C

