WARNING
Observe the following instructions for lifting the vehicle.
If the wheel has to be changed on a slope, first of all block the opposite
■
wheel with a stone or similar object to prevent the vehicle from unexpectedly
rolling away.
Secure the base plate of the lifting jack with suitable means to prevent pos-
■
sible moving. A soft and slippery ground under the base plate may move the
lifting jack, causing the vehicle to fall down. It is therefore always necessary to
place the lifting jack on a solid surface or use a wide and stable base. Use a
non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled
stones, tiled floor, etc.
Only attach the lifting jack to the attachment points provided for this pur-
■
pose.
Always raise the vehicle with the doors closed.
■
Never position any body parts, such as arms or legs under the vehicle, while
■
the vehicle is raised with a lifting jack.
Never start the engine when the vehicle is raised – risk of injury.
■
CAUTION
The prescribed tightening torque for the wheel bolts is 110 Nm for steel and
■
light alloy wheel rims.
If the wheel bolts are fastened too tightly, this can cause damage to the anti-
■
theft wheel bolt and the adapter.
Note
The anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part-
■
ner.
The national legal requirements must be observed when changing a wheel.
■
Preliminary work
First read and observe the introductory information and safety warn-
ings
on page 138.
Always change a wheel on a level surface as far as possible.
The following steps must be carried out before actually changing the wheel:
›
Let all of the occupants get out. While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine.
›
Move the gearshift lever into Neutral or, for an automatic gearbox, move the
selector lever into position N.
›
Firmly apply the handbrake.
›
Remove the vehicle tool kit
wheel from the luggage compartment.
Changing a wheel
First read and observe the introductory information and safety warn-
ings
on page 138.
›
Remove the full wheel trim
» page 135
›
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
» page
140.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground
» page
141.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.).
›
Remove the wheel.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Alternately tighten the wheel bolts opposite each other using the wheel
wrench (crosswise) and then tighten the anti-theft wheel bolt
›
Reinstall the wheel trim/wheel trim cap or the caps.
WARNING
All bolts must be clean and must turn easily.
■
Under no circumstances grease or oil the wheel bolts!
■
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
■
rect
» page
131.
Follow-up work
First read and observe the introductory information and safety warn-
ings
on page 138.
The following steps must also be performed after changing the wheel.
» page 138
and the spare wheel
» page
or caps
» page
135.
» page
Emergency equipment and self-help
134, Spare
140.
139