Sym Mio 50 Service Manual page 160

Installation
Place the master cylinder onto handlebar, and
install the split ring and bolts. The "UP" mark on
the split ring should face upward.
Align the split ring on the master cylinder seat with
the alignment point on the handlebar.
Tighten the upper bolt of the seat to specified
torque value, and then tighten lower bolt to the
same specified torque value.
Install the brake lever, and connect leads to brake
light switch.
Connect brake hoses with 2 new washes.
Tighten the brake hose bolt to the specified torque
value.
Torque value: 3.3~3.7kgf-m
Make sure the hose is installed correctly.
Caution
Improper routing may damage leads, hoses
●
or pipes.
Caution
Kink of brake leads, hose or pipe may reduce
●
brake performance.
Add recommended brake fluid into the system and
conduct the air-bleeding job for the system.
To this chapter contents
Sealing washer
Hose bolt
13. Brake
Mounting seat
Split ring
"UP" mark
Brake hose
13-11