Brake Caliper - Sym Mio 50 Service Manual

13. Brake

Brake Caliper

Removal
Place a container under the brake caliper, and
loosen the brake hose bolt and finally remove the
brake hoses.
Caution
Do not spill brake fluid on painted surfaces.
●
Remove two caliper bolts and the caliper.
Make sure the brake lining condition. Replace
the lining if the brake lining wear limitation groove
close to the brake disc.
Brake Lining Replacement
Compress the caliper and let the brake lining out
of the caliper mounting plate. Compress the brake
lining locking spring. Remove the inner brake
lining firstly and then remove the outer brake
lining.
Compress the brake caliper at first as installation.
Install the inner brake lining firstly, and then install
the outer brake lining.
Installation
Install the brake caliper and tighten the attaching
bolts securely.
Torque: 3.1~3.5kgf-m
Caution
Use M8 x 35 mm flange bolt only.
●
Long bolt will impair the operation of brake
●
disc.
Use two seal washers and hose bolts to lock the
hose and brake caliper in place.
Torque: 3.3~3.7kgf-m
Refill up the brake fluid to the reservoir and make
necessary air bleeding.
13-8
To this chapter contents
2 Bolts
Brake lining
Locking spring
Brake lining
Piston
Locking spring
Hose bolt
Brake lining wear
limitation groove
Caliper
mounting plate
Brake caliper