Sym Mio 50 Service Manual page 107

8. V-Belt Drive System / Kick Starter
Clutch Block Replacement
Remove snap and washer, and the remove clutch
block and spring from driving plate.
Check if spring is damage or insufficient elasticity.
Check if shock absorption rubber is damage or
deformation. Replace it if necessary.
Apply with grease onto setting pins.
Apply with grease onto setting pins. But, the
clutch block should not be greased. If so, replace
it.
Install new clutch block onto setting pin and then
push to specified location.
Caution
Grease or lubricant will damage the clutch
block and affect the block's connection
capacity.
Install the spring snap into groove with pliers.
8-12
To this chapter contents
Spring
Clutch block
Shock absorption
rubber
Shock absorption rubber
Clutch block
Spring
Drive plate
Snap ring
Setting pin