Sym Mio 50 Service Manual page 109

8. V-Belt Drive System / Kick Starter
Installation of Clutch / Driven Pulley
Assembly
Install new oil seal and O-ring onto sliding driven
face. Apply with specified grease to lubricate the
inside of sliding driven face.
Install sliding driven face onto driven face.
Install guide pin and guide pin roller.
Install oil seal collar.
Install driven pulley spring and clutch into clutch
spring compressor, and press down the assembly
by turning manual lever until mounting nut that can
be installed.
Hold the compressor by bench vise and tighten
the mounting nut to specified torque with special
nut wrench.
Remove the clutch spring compressor.
Torque value: 5.0~6.0kg-m
Install clutch/driven pulley and driving belt onto
driving shaft.
8-14
To this chapter contents
Oil seal
O-ring
Sliding driven face
O-ring
Oil seal collar
Special nut wrench
Guide pin
Oil seal
Guide pin roller
Clutch spring compressor
Specified
grease