Table of Contents
Advertisement
8.
Start the heater.
9.
Leak test all gas joints.
10. Check the air shutter following the directions below.
Air Shutter Adjustment
Let the heater burn for fifteen minutes (make sure the logs and glass are in place). The flames should be
yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
Air Shutter Adjustmen
Correct
Flames should be blue at the
base, yellow-orange on the top.
Burner Air Shutter Control
Right = Less Air
Left = More Air
NOTE: Use pliers to adjust the air shutter (it will be hot).
Typically, the air shutter is more closed (right) on NG, more
open (left) on LP.
11. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame on low
position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your Travis dealer
for a remedy.
12. Give this manual to the home owner for future reference and fully explain operation of this heater. For comprehensive
operating and maintenance instructions, refer to the Owner's Manual (part # 100-01253).
ACID WASH WARNING: Make sure any masonry that has been treated with acid wash has been properly neutralized (this is
used primarily with brick faces). Acid wash (muriatic acid) is used to remove excess mortar.
© Travis Industries
Installation
(for qualified installers only)
Not Enough Air
If the flames are too tall or sooty on the
ends, open the air shutter.
4140108
33
Too Much Air
If the flames are all blue and
short, close the air shutter.
100-01353
Hide quick links:
Advertisement
Table of Contents
