Intake Restrictor
The intake restrictor is accessed by removing the burner (see LP Conversion Instructions on page 39 for details).
The intake restrictor is shipped in the open position (position # 1). Follow the directions below to change the
intake restrictor to position # 2 or # 3.
The intake restrictor is
located behind the burner,
on the rear wall of the
firebox.
Position # 1 (stock - open)
Position # 2
Loosen the three screws
shown to the right (1/4"
nutdriver). Then slide the
restrictor down and re-
tighten the screws.
Position # 3
Follow the directions above
for position # 2. Then
loosen the four nuts shown
to the right (11/32"
nutdriver). Then slide the
restrictor extension down
and re-tighten the nuts.
© Travis Industries
Installation
(for qualified installers only)
4140108
21
100-01353