How To Set The Watch; Setting The Alarm - Polar Electro Vantage NV User Manual

HOW TO SET THE WATCH

In the Time of Day display you can set the following three watch
functions:
- Alarm
- Time
- Date
Each function is represented by a block in the graphic bar in the above
order. A flashing block means that you are setting the corresponding
function.
Setting the 12/24h display
1. In the Time of Day display, press and hold SET/
START/STOP. Release.
12 h mode with AM/PM indicator is
activated.
2. Press and hold again. Release.
24 h mode is activated.
3. The chosen mode is now used in all watch and
alarm functions.
If you chose the 24 h mode you can skip those parts in
the following instructions, which advise you to set AM or
PM.
Start here for the setting of alarm, time and/or date:
1. In the Time of Day display press the SET/START/STOP-
button.
• SET starts to flash in the upper right corner of the display.
• ALM appears on the display.
• Alarm symbol starts to flash.
• The uppermost block of the graphic bar on the right, represent-
ing the setting of Alarm, starts to flash.
2. Go through the setting of alarm, time and date step by step by
following the instructions.
8
You can also go directly to set just one particular function by pressing
SET/START/STOP shortly as many times as needed until you see the
corresponding symbol of the desired function in the display and the
block flashing. Now follow the instructions for setting that particular
function.

Setting the alarm

Alarm Symbol is flashing.
1. Press SIGNAL/LIGHT to set the alarm on
( appears) or alarm off (
2. Press STORE/LAP/RECOVERY to lock your
selection.
AM starts flashing.
3. Press SIGNAL/LIGHT to select AM or PM.
4. Press STORE/LAP/RECOVERY to lock your
selection.
The first two digits, representing the hours, start
flashing.
5. Press SIGNAL/LIGHT to select the desired hour.
The digits run faster if you press and hold the SIGNAL/LIGHT button.
Release the button when the desired value is approaching.
6. Press STORE/LAP/RECOVERY to lock your selection.
The last two digits, representing the minutes, start flashing.
7. Press SIGNAL/LIGHT to select the desired minutes.
8. Press STORE/LAP/RECOVERY to lock your selection.
9. Press SET/START/STOP to enter the time setting mode.
AM starts flashing.
10. Now continue from Setting the time.
To return immediately to Time of Day display, press the SELECT button
twice.
When the alarm comes on it will sound for one minute or you can turn
it off by pressing STORE/LAP/RECOVERY button.
disappears).
9