Audience; Ce Marking - Eaton 93PM User And Installation Manual

30-200 kw ups
Table of Contents

Advertisement

CAUTION
Installation or servicing should be performed by qualified service personnel
knowledgeable of batteries and required precautions. Keep unauthorized personnel away
from batteries. Consider all warnings, cautions, and notes before installing or replacing
batteries. DO NOT DISCONNECT the batteries while the UPS is in Battery mode.
Replace batteries with the same number and type of batteries as originally installed in the
UPS.
Disconnect the charging source prior to connecting or disconnecting terminals.
Determine if the battery is inadvertently grounded. If it is, remove the source of the
ground. Contacting any part of a grounded battery can cause a risk of electric shock. An
electric shock is less likely if you disconnect the grounding connection before you work
on the batteries.
Proper disposal of batteries is required. Refer to local codes for disposal requirements.
Do not dispose of batteries in a fire. Batteries may explode when exposed to flame.
Keep the UPS door closed and front panels installed to ensure proper cooling airflow and
to protect personnel from dangerous voltages inside the unit.
Do not install or operate the UPS system close to gas or electric heat sources.
The operating environment should be maintained within the parameters stated in this
manual.
Keep surroundings uncluttered, clean, and free from excess moisture.
Observe all DANGER, CAUTION, and WARNING notices affixed to the inside and outside
of the equipment.

1.1 Audience

The intended audience of this manual are people who plan the installation, install, and use the UPS.
This manual provides guidelines for checking the delivery, installing, and operating of the UPS.
The reader is expected to know the fundamentals of electricity, wiring, electrical components and
electrical schematic symbols. This manual is written for a global reader.
NOTE
Read the manual before operating or working on the UPS.

1.2 CE marking

The product has the CE marking in compliance with the following European directives:
• LV Directive (Safety) 2006/95/EC
P-164000249
Revision 2
30-200 kW
User's and Installation Guide
3

Advertisement

Table of Contents
loading

Table of Contents