Supplies - Monarch 9855 Operator's Handbook Manual

S u p p l i e s
For high temperature or high humidity environments, contact Paxar for
supply recommendations. Continuous (non-indexed) supply does not have
perforations or black marks and must be used in continuous mode. We
recommend using continuous supply with a tear bar or the optional knife. If
you purchased the optional knife, you cannot use the tear bar. Aperture
supplies are tags or labels with holes (or openings) in them. The supply is
sensed using the holes. The holes can be only on the edge or in the center
of the supply.
Center Aperture
Supply Types:
Supply Widths:
Supply Lengths:
Total Thickness:
Thermal Transfer or Direct
0.75 inches (19 mm) minimum
4.25 inches (108 mm) maximum
0.32 inch (8 mm) minimum
0.75 inch (19 mm) minimum for tags
1.2 inches (30 mm) minimum for cutting tags
17.5 inches (445 mm) maximum
7to 12 mils
7 to 10 mils with the optional knife
Edge Aperture
Specifications A-3