Table of Contents
Advertisement
Using the Main Menu
Device
The Device menu allows
you to configure hard drive
and PTZ settings and
format a USB flash drive
(not included).
• For details on connecting PTZ cameras
(not included), see "Appendix H:
Connecting a PTZ Camera" on page 123.
Configuring Hard Drive settings
To format the hard drive:
ATTENTION: Formatting the HDD
all data
erases
This step cannot be undone.
1
Select the HDD tab.
2
Click the checkbox under Select to choose
the drive you wish to reformat.
3
Click Format HDD.
4
When the warning window appears, click
OK. Wait for the system to format the hard
drive.
To set the hard drive recording mode
(loop recording or linear recording):
1
Select the HDD tab.
2
Select the checkbox beside the hard drive
you wish to configure.
46
on the hard disk.
3
In the Overwrite drop-down menu, select
Auto. (recommended), or select the
desired duration the hard drive should
retain its data.
NOTE: If overwrite recording is enabled, the
system's hard drive automatically
re-writes the hard drive's oldest
content (first in first out).
4
Click Apply to save your settings.
Formatting USB Flash Drives
ATTENTION: Formatting a USB flash
all data
drive erases
This step cannot be undone.
1
Insert a USB flash drive (not included) into
one of the USB ports on the rear panel of
the DVR.
2
In the main menu, Device>HDD.
3
Click Format USB, then click OK. Wait for
formatting to complete.
on the drive.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
