Center Flue Adapter (Part # 99300137)
The center flue adapter centers the flue and has a short "tee". This positions the vent closer to the
stove than a normal "tee", allowing for tighter installations and easier access.
•
The adapter is made by Simpson Duravent®.
vent for the entire system.
Hint
To ease cleaning of the "tee", we recommend the use of the twist-on cap manufactured
by Simpson Duravent® (part number 3067A). This component replaces the cap on the
"tee" and allows access to the cleanout without tools.
1)
The center flue adapter has two pieces: a custom "tee" and a 45° elbow. The 45° elbow,
which centers the vent, is not required (proceed to step 2 if not using). Before installing,
remove the elbow, apply high-temperature silicone to the pipe joint and attach the elbow
to the "tee" so the elbow bends upwards when attached. Use three screws (use self-
drilling "zip " or metal screws) to secure these two pieces together.
2)
Apply high-temperature silicone to the "tee" pipe joint where it connects to the stove.
Use three screws (use self-drilling "zip " or metal screws) to secure the "tee" to the stove.
Gold Grill (Part # 93005034)
The decorative gold grill replaces the black grill,
accenting the shape of the insert. Follow the
directions below to install.
Travis Industries
Optional Equipment
Center flue adapter
centers the flue
when looking from
the front.
Vent External
Radius = 1-7/8"
17-1/2" (from base of insert)
Removable
clean-out
Use Simpson Duravent®
Approx.
3"
4 0 2 0 2 0 4
3 3
Use a phillips screwdriver to
remove the two screws holding
the black trim in place. Use
the same screws to attach the
gold trim.
Phillips
Screwdriver
9 3 5 0 8 0 5 1