Optional Equipment; Surround Panel Installation - Lopi Spirit Bay Owner's Manual

Surround Panel Installation

Surround panel size is determined by the size of the fireplace opening. Panels that overlap the
fireplace opening are usually more attractive. The table below details the size of the surround
panels when installed. Questions should be directed towards your dealer.
SURROUND PANEL SIZE
8"
10"
12"
Place the insert 12" from the fireplace opening before installing the surround panels.
1.
3.
4.
NOTE: Discard the insulation that comes with the surround panels (for wood stoves only). The
panels must not form an air-tight seal against the fireplace.
(See table below for part number)
HEIGHT
27 3/4"
29 3/4"
31 3/4"
Follow the directions in the illustration below to install the side panels.
Place two clips
1.
(included with the
panels) over one of
the surround panels
(flat side in).
Rotate the panel
2.
back and place it so
the inside flange fits
inside the side
convection jacket.
Note how the cook
top fits into the
notch.
Install the top panel (see the illustration below). Adjust the top panel so its edges
are flush with the side edges of the side panels.
The joggle clips on the
top panel slide over the
offset portion on top of
the side panels and over
the mounting flange.
Mounting Flange
Adjust the position of the side panels so they are: 1) flush with the bottom of the
insert; 2) both the same distance back from the front of the insert; 3) perpendicular
to the floor. Tighten the nuts that hold the side panels in place.
O
PTIONAL
WIDTH
40 1/2
44 1/2
48 1/2
Cook Top
Top of Insert
Side
Convection
Jacket
Insert the two screws
3.
(included with the panels)
Inside through the convection
Flange jacket and into the two
clips installed in step one.
Turn a couple of times but
do not tighten.
4. Repeat for the opposite side.
Top Panel
E
QUIPMENT
P
PART #
99300102
99300103
99300110
Back
of
Insert
25
AGE