Remote Thermostat; Optional Log; Optional Gold Door - Lopi Pioneer Bay Installation And Use Manual

Pellet insert
Hide thumbs Also See for Pioneer Bay:
Table of Contents

Advertisement

Remote Thermostat (Part # 99300653)
Follow the instructions included with the remote thermostat for installation and operation.
Optional Log (Part # 98900126)
!
Make sure the heater has fully
cooled before installation.
1
Open the door (see the instructions
included with the owner's manual.
2
Attach the two log shelf legs to the
cross brace with the four included
nuts. Make sure to use the correct
leg for each side.
3
Install the log shelf assembly and log
following the directions below.
b
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.
Optional Gold Door (part # 99300219)
Remove the black door by sliding
it up and off the door frame.
Slide the gold door onto the door
frame.
HINT: align the bottom joggle
clips over the brackets on the
door and slide into place. Then
lift up slightly on the door to
attach the upper clip.
The door is held in place with 4
joggle clips.
Travis Industries
Optional Equipment
Center the log on the log shelf and
push it back so it rests against
these two tabs.
Left Log Shelf Leg
Nuts
Log Shelf Cross Brace
Place the log shelf assembly so the
a
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
4 0 2 0 2 0 4
Right Log Shelf Leg
3/8" Nutdriver
Door
Door
Frame
9 3 5 0 8 0 5 1
3 5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Heritage bay pi

Table of Contents