Table of Contents
Advertisement
30
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1
Open the door (see page 17). Remove the logs and coals (if installed - page 18)
2
Remove the burner (see illustration below).
d
Pull the burner forward, out
of the firebox.
Burner Replacement:
Make sure the burner is fully seated.
When in place, the pilot flame must align
directly above the burner holes.
Make sure the mixing tubes
slide onto the orifices.
Travis Industries
Optional Equipment
a
Remove the cast floor.
c
Lift the left side of the burner slightly, then slide it to the left
and lift it upwards (lift the burner from below).
Do not lift the burner from the pins.
WARNING:
The burner is fragile -
handle it with care.
Make sure the bolt head on
the bottom of the burner
inserts into this hole.
Mixing Tubes
Replace the pilot hood
after replacing the burner.
Orifices
100-01135
Lift the pilot hood off the pilot
b
assembly (you may need to pull
hard to remove).
Slide the air shutters all the
way to the right before
installing the burner.
NOTE:
Make sure the burner is
fully seated. When in
place, the pilot flame
must align directly above
the burner holes.
4 0 4 0 8 0 9
Advertisement
Table of Contents
