Rocker Cover Installation; Lash Adjuster Installation; Valve Clearance Adjustment - Mitsubishi 4G1 Series General Information Manual

4G1 ENGINE (E - W) -
MD998443
Lash adjuster
Timing belt side
Thickness gauge
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
"HA ROCKER COVER INSTALLATION
(1) Apply the specified sealant to the area shown, then fit
"IA LASH ADJUSTER INSTALLATION
(1) Insert the lash adjuster to rocker arm, being careful not
"JA LASH ADJUSTER INSTALLATION
Fit the lash adjuster onto the rocker arm without allowing
diesel fuel to spill out.

VALVE CLEARANCE ADJUSTMENT

<SOHC 12-VALVE>
(1) Position the No. 1 cylinder at top dead center on the
(2) Adjust the valve clearance at the points shown in the
(3) Loosen the adjusting screw locknut.
(4) Using a feeler gauge, adjust the valve clearance by turning
(5) While holding the adjusting screw with a screwdriver,
Nov. 1995
Aug. 2000
Rocker Arms and Camshafts
the rocker cover.
Specified sealant:
3M ATD part No. 8660 or equivalent
to spill diesel fuel. Use the special tool to prevent adjuster
from falling while installing it.
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to 11A-8-3.)
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to 11A-8-6.)
compression stroke.
illustration.
the adjusting screw.
Standard value: on cold engine
Intake 0.09 mm
Exhaust 0.17 mm
tighten the lock nut.
PWEE9520
PWEE9520-D
11A-8-9
Revised