Oil Filter Installation - Mitsubishi 4G1 Series General Information Manual

11A-10-4
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E - W) -
"EA OIL FILTER INSTALLATION
(1) Clean the filter mounting surface on the front case.
(2) Apply engine oil to the oil filter's O-ring.
(3) Screw on the oil filter until the O-ring is seated on the
"FA OIL FILTER INSTALLATION
(1) Clean the filter mounting surface on the front case.
(2) Apply engine oil to the O-ring of the oil filter.
(3) Screw the oil filter in and tighten the oil filter approximately
Bracket side
Nov. 1995
Aug. 2000
Oil Pump and Oil Pan
mounting surface. Then, give the oil filter one further
turn such that it is torqued to approximately 14 Nm.
Caution
The oil filter must be tightened using a commercially
available filter wrench. If the filter is tightened by hand
only, it will be insufficiently torqued, resulting in oil
leaks.
3/4 of a turn (approx. 16 ± 4 Nm) from where the O-ring
has come into contact with the oil filter mounting surface.
Caution
The oil filter must be tightened using a commercially
available filter wrench. If the filter is tightened by hand
only, it will be insufficiently torqued, resulting in oil
leaks.
PWEE9520
PWEE9520-D Revised