Front Oil Seal Case Installation; Front Oil Seal Installation; Oil Pan Installation; Drain Plug Gasket Installation - Mitsubishi 4G1 Series General Information Manual

MD998305 (M12)
MB991962 (M14)
MD998304 (M12)
MD998306 (M14)
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E–W) –
INSTALLATION SERVICE POINTS
"AA FRONT OIL SEAL CASE INSTALLATION
(1) Clean the sealant application surfaces on the cylinder
(2) Apply a 3 mm bead of form-in-place gasket to the entire
"BA FRONT OIL SEAL INSTALLATION
(1) Place the special tool on the crankshaft's front end and
(2) Apply engine oil to the oil seal lip, then push the oil seal
"CA OIL PAN INSTALLATION
(1) Clean the mating surfaces of the cylinder block and oil
(2) Apply a 4 mm bead of form-in-place gasket to the outer
"DA DRAIN PLUG GASKET INSTALLATION
(1) Replace the drain plug gasket with a new one. Fit the
Oil pan side
Nov. 1995
Apr. 2003
Oil Pump and Oil Pan
block and front oil seal case.
circumference of the oil pan flange.
Specified sealant:
Mitsubishi Genuine
equivalent.
apply engine oil to the its outer circumference.
along the guide by hand until it touches the front case.
Tap the oil seal into place using the special tool.
pan.
circumference of the oil pan flange.
Specified sealant:
Mitsubishi Genuine
equivalent.
new gasket as shown.
PWEE9520
PWEE9520-G
11A-10-3
Part No. MD970389
Part No. MD970389
Revised
or
or