11A-10-2
MD998727
MD998727
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E–W) –
REMOVAL SERVICE POINT
AA" OIL PAN REMOVAL
(1) Remove the oil pan mounting bolts.
(2) Knock the special tool between the oil pan and cylinder
(3) Tapping the side of the special tool, slide the tool along
INSPECTION
1. OIL PUMP
(1) Fit the rotor into the front case.
(2) Check the tip clearance using a thickness gauge.
(3) Check the side clearance using a straight edge and
(4) Check the body clearance using a thickness gauge.
Nov. 1995
Feb. 2001
Oil Pump and Oil Pan
block as shown in the illustration.
the oil pan/cylinder block seal and thus remove the oil
pan.
Standard value: 0.06 – 0.18 mm
thickness gauge.
Standard value: 0.04 – 0.10 mm
Standard value: 0.10 – 0.18 mm
Limit: 0.35 mm
PWEE9520
PWEE9520-E
Revised