Exhaust Camshaft / Intake Camshaft Installation; Beam Camshaft Cap Installation - Mitsubishi 4G1 Series General Information Manual

11A-8a-2
4G1 ENGINE (E - W) -
Approx.
30_
Approx.
17_
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" LASH ADJUSTER REMOVAL
INSTALLATION SERVICE POINTS
"AA LASH ADJUSTER INSTALLATION
While using care not to spill diesel fuel in the lash adjuster,
install the lash adjuster on the rocker arm.
"BA EXHAUST CAMSHAFT / INTAKE CAMSHAFT
(1) Turn the crankshaft to place the No. 1 cylinder at top
(2) Place dowel pins of the camshafts in the positions shown
"CA BEAM CAMSHAFT CAP INSTALLATION
(1) Remove deposits from the liquid gasket coating surfaces
(2) Apply liquid gasket to the five grooves on the bottom
(3) Apply a suitable amount of liquid gasket to the ten positions
Nov. 1995
Aug. 2000
Rocker Arms and Camshafts
Caution
If the lash adjuster is to be reused, be sure to clean
and inspect it before installation. (Refer to 11A-8a-4.)
Caution
If the lash adjuster is to be reused, be sure to clean
and inspect it before installation. (Refer to 11A-8a-4.)
INSTALLATION
dead center.
in the illustration.
of the beam camshaft cap and the cylinder head.
surface of the beam camshaft cap by squeezing it to
a thickness of 3 mm.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
NOTE
Install the beam camshaft cap within 15 minutes of
application of liquid gasket.
as shown on the top surface of the cylinder head.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
NOTE
Install the beam camshaft cap within 15 minutes after
application of liquid gasket.
PWEE9520
PWEE9520-D Added