Removal Service Point Aa Crankshaft Bolt Removal; Installation Service Points Aa Distributor Installation; Crankshaft Pulley / Bolt Installation; Cam Position Sensor Support Installation - Mitsubishi 4G1 Series General Information Manual

4G1 ENGINE (E–W) –
MD998781
Alignment mark
MD998781
Crankshaft pulley
Degrease
Crankshaft
bolt
Washer
Shear-drop
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" CRANKSHAFT BOLT REMOVAL
(1) Lock the flywheel or drive plate in position using the special
INSTALLATION SERVICE POINTS
"AA DISTRIBUTOR INSTALLATION
(1) Turn the crankshaft clockwise until cylinder No. 1 is at
(2) Align the alignment marks on the distributor housing and
(3) Fit the distributor onto the engine, aligning the stud bolts
Alignment mark
"BA CRANKSHAFT PULLEY / BOLT INSTALLATION
(1) Hold the flywheel or drive plate using the special tool.
(2) Clean the bolt hole in crankshaft, crankshaft bolt and
(3) Degrease the cleaned seating surface of the crankshaft
Crankshaft
(4) Install the crankshaft pulley.
(5) Apply oil to the threads of crankshaft bolt and the outer
(6) Tighten the crankshaft bolt to the specified torque of 125
Clean
"CA CAM POSITION SENSOR SUPPORT
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
Nov. 1995
Aug. 2001
Alternator and Ignition System
tool shown in the illustration, then loosen the crankshaft
bolts.
top dead center on its compression stroke.
coupling.
with the slots in the distributor mounting flange.
crankshaft pulley's seating surface.
pulley.
surface of washer.
Nm.
INSTALLATION
the area shown.
Specified sealant:
Mitsubishi Genuine
equivalent
PWEE9520
PWEE9520-F
11A-3-5
Part No. MD970389
Revised
or