Mitsubishi 4G1 Series General Information Manual page 43

23 cogs
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E–W) –
(4) Adjust the timing belt so that 23 cogs will fall within the
(5) While aligning the exhaust camshaft sprocket timing
Timing marks
(6) Ensure that the timing marks on the exhaust camshaft
(7) Loosen the timing belt tensioner securing bolt, which has
Securing bolt
(8) Remove the paper clips, etc.
(9) Make two turns of the crankshaft sprocket in clockwise
Nov. 1995
Feb. 2001
Timing Belt
range between the timing marks on the intake and exhaust
camshaft sprockets. Secure the belt at this position with
a paper clip, etc.
marks, install the timing belt on the idler pulley, crankshaft
sprocket, and the timing belt tensioner in that order.
sprocket and on the crankshaft sprocket are in alignment.
temporarily been tightened, a quarter to half turn. Utilizing
tensioner spring tension, give tension to the timing belt.
direction to ensure that the timing marks on each camshaft
sprocket are in alignment.
Caution
Operation under item 9 above is performed in order
to give a constant tension to the timing belt by utilizing
camshaft driving torque. Observe the number of turns
of the sprocket mentioned above. Do not turn the
crankshaft sprocket counterclockwise direction.
PWEE9520
PWEE9520-E
11A-4-9
Revised