Oki OKIFAX 5750 Maintenance Manual page 896

5.2 Setting Items
You can alter network settings by selecting UF93: NETWORK SETTINGS. To print from
Windows using Lpr, it is necessary to set the IP ADDRESS. This is not required if printing from
NetWare only, but it is necessary for using InternetFAX functions.
1: IP ADDRESS
Sets the IP address.
2: SUBNETMASK
Sets the subnet mask.
3: DEFAULT GATEWAY
Sets the default gateway address.
The following three settings are specific to Network Printing.
• UF80: LAN PRINT T.O. (5 sec., 30 sec., 5min.)
It is impossible to judge whether printing data is not being transmitted due to network
delay or the end of the data stream. This time-out configuration allows the device to
cancel a print job when no printing data can be found after a specified time has elapsed
since the last data was submitted. If the default configuration is acceptable, please do not
alter it.
• UF81:PAPER SIZE CHECK (ON, OFF)
With this configuration ON, an alarm will be displayed at the LCD when the paper size
specified from the PC and that of the tray specified by fax machine are different. If this
alarm is displayed set the correct paper size in the specified tray. Printing will begin when
the tray is closed. After the printing, set the same recording paper as configured for the
tray, or alter the tray configuration to the correct paper size. With this configuration OFF,
printing will be conducted neglecting the paper size difference.
• UF82: AUTO TRAY SW. (ON, OFF)
With this configuration ON, printing will be done using paper in another tray when paper is
out in the 1st or 2nd tray and paper size of the1st and 2nd tray is the same.
41285901TH Rev.3
896 /