Oki OKIFAX 5750 Maintenance Manual page 205

Setting values are defined for each country code.
For more details, see Section 2.9.6, "Defaults."
The setting data must be transferred to the G3 Option.
No. Item
40 Redial Tries
41 Redial Interval
42 Auto Start
43 Dial Tone Detect
44 Busy Tone Detect
45 MF/DP
41285901TH Rev.3
Table 2.9.5.4 Dial Options (1/3)
Sets on the redial tries to meet the regulations of the installed
country.
1) Setting values
Country code =
Other than FRE: 0-10 (in one-try steps)
FRE: 1-5 (in one-try steps)
Set an automatic redialing interval to meet the regulations of
installed country.
1) Setting values
Country code =
Other than FRE: 1-6 (in one-minute steps)
FRE: 1-12 (in one-minute steps)
Determine whether a call is to be originated automatically
without pressing the START key after specifying a destination
with a speed dial key.
1) Setting values
ON (Automatic origination)/OFF (Call is not originated until
START key is pressed)
Determine whether a dial tone is to be detected.
1) Setting values
ON (Detected)/OFF (Not detected)
* Selection is skipped over when the ISDN board is
mounted. (Selection allowed if SERVICE BIT=ON)
Determine whether a busy tone is to be detected.
1) Setting values
ON (Detected)/OFF (Not detected)
* Selection is skipped over when the ISDN board is
mounted. (Selection allowed if SERVICE BIT=ON)
Determine whether MF or DP is to be used for call origination.
1) Setting values
MF (Tone)/DP (Pulse)
* Selection is skipped over when the ISDN board is
mounted. (Selection allowed if SERVICE BIT=ON)
Specifications
205 /