Oki OKIFAX 5750 Maintenance Manual page 872

• UF93: NETWORK SETTINGS
By selecting UF: 93, you can alter the following network settings.
Note: After making changes to these settings, you have to press the MENU key to put
the machine in stand-by mode. After a few seconds' pause, the LCD will indicate
that the Network Card is being initialised, and the data on the Network Card will
be updated when this message disappears. Please do not press the MENU key
again while the initialisation message is on display as it may prevent the settings
from being updated correctly.
1: IP ADDRESS
Sets the IP address.
2: SUBNETMASK
Sets the subnet mask.
3: DEFAULT GATEWAY
Sets the default gateway address.
4: SMTP SERVER NAME
Either the IP address or the host name of the SMTP mail server up to 64 characters may
be entered here. The host name (e.g., mail.network.com) can be used if DNS has been
set; otherwise, enter the IP address of the server. The address must include the "." (pe-
riod) dividers (e.g., 192.168.004.123).
Note: You can input Latin letters, numbers and symbols using one-touch keys. To enter
symbols, use either one-touch key 20 or ten key "0". The symbols that can be
used are: ! # & ' ( ) * + , - . / : ; = ? • @ ? " _ % ~
The "~" (tilde) symbol will appear on the LCD as "-1". Both upper-case and lower-
case letters can be used; to switch between the cases, press one-touch key 31
(CAPS key).
5: POP SERVER NAME
Either the IP address or the host name of the POP mail server up to 64 characters may
be entered here. The host name (e.g., mail.network.com) can be used if DNS has been
set; otherwise, enter the IP address of the server. The address must include the "." (pe-
riod) dividers (e.g., 202.250.111.123).
Note: You can input Latin letters, numbers and symbols using one-touch keys. To enter
symbols, use either one-touch key 20 or ten key "0". The symbols that can be
used are: ! # & ' ( ) * + , - . / : ; = ? • @ ? " _ % ~
The "~" (tilde) symbol will appear on the LCD as "-1". Both upper-case and lower-
case letters can be used; to switch between the cases, press one-touch key 31
(CAPS key).
6: POP USER ID
You can enter the user ID registered on the POP3 server, which must be alphanumerical
characters no more than 16 characters long.
Note: You can input Latin letters, numbers and symbols using one-touch keys. To enter
symbols, use either one-touch key 20 or ten key "0". The symbols that can be
used are: ! # & ' ( ) * + , - . / : ; = ? • @ ? " _ % ~
The "~" (tilde) symbol will appear on the LCD as "-1". Both upper-case and lower-
case letters can be used; to switch between the cases, press one-touch key 31
(CAPS key).
41285901TH Rev.3
872 /