Engineering Mode - Vision Fitness X20 Owner's Manual

ENGINEERING MODE

Engineering mode consists of six optional settings. Use the engineering mode
to access information and enable certain features or displays on your console.
ENTERING AND USING ENGINEERING MODE
• Press and hold the UP s and DOWN t keys for approximately three
seconds.
• The console will beep and display engineering modes and optional
settings. Use the UP s or DOWN t keys to scroll through the options.
Press the ENTER key to select the appropriate mode or setting.
OPTIONAL SETTINGS
S E T T I N G D E S C R I P T I O N
ENG1 – LCD TEST TEST USED BY SERVICE TECHNICIANS TO TEST LCD DISPLAYS
TEST USED BY SERVICE TECHNICIANS TO TEST EDDIE CURRENT BRAKE SYSTEM
ENG2 – HARDWARE TEST
ENG2 – ACCUMULATED TIME/ MEASURES TOTAL TIME USED IN HOURS AND MEASURES TOTAL DISTANCE USED IN
ACCUMULATED DISTANCE MILES
ENG3 – MACHINE AND USED BY SERVICE TECHNICIANS TO CHECK IF THE CONSOLE IS SET TO BIKE MODE OR
ELLIPTICAL MODE, SHOWS YOU IF THE EXERCISE FEEDBACK IS SET TO THE ENGLISH
UNITS MODE
(MILES) OR METRIC (KILOMETERS) SYSTEM AND DISPLAYS THE SOFTWARE VERSION
ENG4 – DEFAULT TIME SET ALLOWS YOU TO SET THE TIME THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS
ENG5 – DEFAULT LEVEL SET ALLOWS YOU TO SET THE LEVEL THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS
ENG6 – PRODUCT SELECTION ALLOWS YOU TO CONFIGURE YOUR CONSOLE TO THE PROPER PRODUCT (BIKE OR
AND MODEL CONFIGURATION ELLIPTICAL) AND MODEL NUMBER IF IT WAS NOT DONE CORRECTLY IN THE INITIAL SET UP
• Use the UP s and DOWN t keys within each setting to change the setting.
• Press the ENTER key to save settings.
• To EXIT engineering mode, press and hold the START key for three seconds.
16 17