Using Facility Engineering Mode; Settings - Vision Fitness X6850HRT Owner's Manual

USING FACILITY ENGINEERING MODE SETTINGS
Engineering mode is used to customize your Incline Elliptical Trainer for
your facilities needs, or to view useful information about your Incline
Elliptical Trainer. These features are only accessible to your staff when they
press the keys in a specific sequence.
USING ENGINEERING MODE
• To enter press and hold the RESISTANCE UP and RESISTANCE
DOWN arrow keys simultaneously for four seconds or until you see
the message.
• When in engineering mode you can scroll through the optional
settings by using the UP and DOWN arrow keys. Press the ENTER
key to select the setting you wish to view or modify.
• Use the UP and DOWN arrow keys to modify the settings.
• Press the ENTER key to save your setting.
• Press and hold the PAUSE key for four seconds to exit engineering mode.
The following settings will be available in the engineering mode:
MAXIMUM TIME –
the workouts can be set for. This feature is necessary for busy facilities
that may want to limit the amount of time their users are on the Incline
Elliptical Trainer. The default is 99 minutes.
USER DEFAULT TIME –
for setup mode. This default time will also be used when the exerciser
presses START for a quick start program.
USER DEFAULT AGE –
for setup mode. This is particularly useful when the Incline Elliptical
Trainer is placed at a facility where the user's age range is very
26
specific, such as a school. This default age will also be used when
the exerciser presses START for a quick start program.
The manager has the ability to set the maximum time
This mode allows you to set a specific default time
This mode allows you to set a specific default age