Mdc Module - Toshiba Satellite M205 Maintenance Manual

4 Replacement Procedures

4.9 MDC Module

Removing the MDC Module
Remove the MDC Module (Modem Daughter Card) according to the following procedures
and Figures 4-18, after checking that the computer is turned off in boot mode.
CAUTION: Remove the MDC module after turning off the computer. If this is violated,
the computer or MDC module can be damaged.
1. Remove the two M2x2 black flat head screws securing the MDC module.
2. Left the MDC module and disconnect it from CN15 on the system board.
3. Disconnect the MDC cable from connector JP1 on the MDC card.
CAUTION: Do not touch the connectors on the MDC module or in the computer.
Contaminated connectors can cause MDC module failures.
CN8
M2x2 black flat head screw
4-34
Satellite M200/M205 / Satellite Pro M200/ EQUIUM M200/ SATEGO M200
MDC cable
CN15
Figure 4-18 Removing the MDC module
4.9 MDC Module
JP1
MDC card
Maintenance Manual