4 Replacement Procedures
4.9
MDC Module
Removing the MDC Module
Remove the MDC Module (Modem Daughter Card) according to the following procedures
and Figures 4-13, after checking that the computer is turned off in boot mode.
CAUTION: Remove the MDC module after turning off the computer. If this is violated,
the computer or MDC module can be damaged.
1. Remove the two M2x2 black flat head screws securing the MDC module.
2. Left the MDC module and disconnect it from CN7 on the system board.
3. Disconnect the MDC cable from connector J1 on the MDC card.
CAUTION: Do not touch the connectors on the MDC module or in the computer.
Contaminated connectors can cause MDC module failures.
MDC card
4-28
M2x2 black flat head screw
CN7
MDC cable
Figure 4-13 Removing the MDC module
Satellite/Satellite Pro/A500/A505/A507/dynabook
4.9 MDC module
Maintenance Manual