Toshiba Satellite M205 Maintenance Manual page 172

4 Replacement Procedures
Installing the CPU Cooling Module and Fan (for VGA card Model)
Install the cooling Module according to the following procedures and Figures 4-21, 4-22.
CAUTION: When installing the cooling module, keep the following in mind:
1. Be sure to confirm the correct position for the module.
2. Secures the relevant screws on the main board according to the number sequence
sealed on heat sink module.
NOTE: Apply silicon grease with a special syringe to cover the surface of the CPU chip
completely.
1. If silicon grease is already applied to the CPU and fan module, wipe them off with a
cloth.
By using a special syringe, apply silicon grease G7762 to the CPU chip center so that
the entire CPU chip is covered with the grease G7762.
2. Install the CPU cooling module into the correct position in the computer.
3. Place the CPU cooling module and bracket in the correct position and secure them
with four M2x4 black flat-head screws.
4-42
Satellite M200/M205 / Satellite Pro M200/ EQUIUM M200/ SATEGO M200
4.12 CPU Cooling Module
Maintenance Manual