Displaying And Changing Stack Information; Moving The Focus Of The Command Line Interface - 3Com SuperStack II Manual

Displaying and
Changing Stack
Information
Moving the Focus of
the Command Line
Interface
You can display and change information about the Switch units in the
stack or the stack as a whole using the commands on the System menu.
These commands allow you to:
Move the focus of the command line interface from one Switch unit in
the stack to another
Specify administration details for the stack
Display administration details for the current Switch unit in the stack
Display summary information about the Switch units in the stack
Change the password for the current user
Specify, display, modify and remove user details for the stack
Display and modify the access rights for the access levels in the stack
Enable and disable all forms of remote access to the stack
Reset the Switch units in the stack
Initialize the Switch units in the stack
Upgrade the management software of the Switch units in the stack
Configure intelligent modules in the stack.
Many commands in the command line interface perform their actions on
a single Switch unit in the stack — the current Switch. You can move the
focus of the command line interface from one unit in the stack to another
using the command on the System menu.
unit
To move the focus:
1 At the Top-level menu, enter:
system unit
The following prompt is displayed, allowing you to enter a unit number:
Select unit [1]:
2 Enter the number of the unit to be managed.

Displaying and Changing Stack Information

141