The Getting Started Pages - 3Com SuperStack II Manual

46 C 3: W
HAPTER ORKING
The Getting Started
Pages
W W I
ITH THE EB NTERFACE
When you access the web interface for the first time or after a
power-off/on cycle, a set of Getting Started pages are displayed. The first
Getting Started page, Getting Started - Introduction is shown in
Figure 3 The Getting Started - Introduction page
The Getting Started pages allow you to enter basic setup information for
the stack. As you go through the pages, you are asked to enter:
1 A descriptive name for the stack.
2 Whether you want to allocate IP information for the stack, or whether
you want a BOOTP server (if you have one) to allocate the information
automatically.
If you choose to allocate IP information yourself, you are prompted to
enter the following information:
An IP address for the stack. For more information about IP addresses,
see "Managing a Switch Over the Network"
A subnet mask for the stack. For more information about subnet
masks, see "Subnets and Using a Subnet Mask"
An IP address for the default router, if one exists on your network.
If you choose to allocate IP information using a BOOTP server, no prompts
are displayed.
Figure
on page 38.
on page 39.
3.