3Com SuperStack II Manual page 232

232 A B: M
PPENDIX ANAGEMENT
S U
OFTWARE PGRADE
c Copy the management software file to the upgrade directory on the
hard drive.
d Change your directory to the upgrade directory on the hard drive.
5 At the MS-DOS prompt, enter the upgrade command:
update <file>
<file> is the name of the management software file. Note that the
software files have the format s2sxx_yy.bin, where xx_yy is the
version number.
CAUTION: You must use the s2sxx_yy.bin format, otherwise the
upgrade fails.
You can also use the following parameter with the upgrade command to
specify the serial (COM) port to use for the PC (COM 1) or (COM 2). The
default for this is COM 1:
or
-c 1 -c 2
An example of the upgrade command with this parameter is:
update -c 1 s2sxx_yy.bin
6 Power-down the Switch.
7 At your PC, press [Return].
8 Power-up the Switch immediately (within 5 seconds).
The utility transfers the management software to the Switch.
When the management software has been transferred, your PC displays
the following message:
Update completed successfully.
Update another unit? (y/n)
9 If you want to upgrade the management software of another Switch,
enter y (for yes), otherwise, enter n (for no).
U
TILITY