3Com SuperStack II Manual page 103

Table 8 Command line interface commands
Command
feature analyzer display Displays information about the roving analysis
feature analyzer remove
feature analyzer start
feature analyzer stop
feature
broadcastStormControl
feature resilience
define
feature resilience
detail
feature resilience
remove
feature resilience swap
feature trunk addPort
feature trunk detail
feature trunk removePort Removes a single port from a trunk on the
feature trunk summary
ip interface bootp
ip interface define
ip interface display
ip ping
ip initializeConfig
snmp community
A Quick Guide to the Commands
What does it do?
port configured in the stack.
Removes the designated roving analysis port
from the current port.
Specifies the roving analysis monitor port (that
is the port from which data will be copied) and
starts monitoring by the analysis port.
Disables roving analysis and removes the
monitor port from the roving analysis
configuration.
Enables and disables Broadcast Storm Control.
Creates a resilient link.
Displays summary information about all resilient
links present in the stack.
Deletes a resilient link.
Swaps over the "active" resilient link.
Adds a single port to a trunk.
Displays detailed information about the trunks
supported by the current Switch unit.
current Switch unit.
Displays summary information about all trunks.
Enables and disables BOOTP for the current
Switch unit in the stack.
Specifies the IP information for the current
Switch unit in the stack.
Displays the IP information for the current
Switch unit in the stack.
Allows you to ping other devices on your
network.
Allows you to reset the IP configuration back to
factory defaults. This command operates on the
whole stack.
Specifies SNMP community strings for the stack.
103