Installation - TANDBERG MediaPlace MXP User Setup Manual

Table of Contents

Advertisement

[ 10 ]

INSTALLATION

;,"'+--+'53,
The TANDBERG MediaPlace components are: TANDBERG set-top codec (770/880/
990), lockable mobile cart, high resolution projector, DVD/VCR combination unit,
and audio system with speaker and microphone.
Refer the following pages for system setup and installation.
<$#2+('53,"
• Never install telephone wiring during a lightning storm. Avoid using a
telephone (other than a cordless type) during an electrical storm. There may
be a remote risk of electrical shock from lightning.
• Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
• Never touch uninstalled telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
• The socket outlet shall be installed near to the equipment and shall be
easily accessible.
• Never install cables without first switching the power OFF.
• 1TR6 network type is not approved for connection directly to the telecom-
munications network. This network type is only to be used behind a PABX.
• X.21 network type is not approved for connection directly to the telecom-
munications network. This network type is only to be used together with
already approved equipment, and is not meant for direct connections to the
telecommunication networks.
• V.35/RS-449/RS-366 network type is not approved for connection directly to
the telecommunications network. This network type is only to be used
together with already approved equipment, and is not intended for direct
connection to the telecommunication networks.
• This product complies with directives: LVD 73/23/EC, EMC 89/366/EEC,
R&TTE 99/5/EEC
TANDBERG MediaPlace Videoconferencing System
D5029302

Advertisement

Table of Contents
loading

Table of Contents