Lower Plastic Shield/Support Assembly - IBM 4247 Maintenance Information

Screws
Figure 187. Paper Feed Belt Tension Lever Screws. (Viewed From Right Side)
Replacement
1. Follow the removal steps in reverse order.
Attention: Ensure that cables do not rub on paper feed belt.
2. Perform the paper feed belt tension service check. See "Paper Feed Belt" on page 281.

Lower Plastic Shield/Support Assembly

Before You Begin
Determine whether your printer has a one-piece or two-piece version. If the support assembly has 2 screws (see
Figure 188 on page 452), the printer contains a two-piece version; if the support assembly does not have 2
screws, the printer contains a one-piece version.
451
Chapter 5. Removals and Adjustments