IBM 4247 Maintenance Information page 114

Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions
Make the following checks:
19.
v Inspect the condition of the paper bail plastic shield
and lower plastic shield. Ensure that the shields are
firmly attached.
Note: If you suspect lower plastic shield damage,
determine which version part is installed. If the lower
plastic shield is attached with 2 screws, remove the
screws to remove the plastic shield, and inspect it for
damage. If the lower plastic shield is not attached
with 2 screws, remove the platen to inspect it.
Shield
v Locate and remove any paper debris, label debris, or
label adhesive from the forms path.
Are these checks OK?
Yes
Go to step 20 on page 115.
No
Repair, as needed.
Run T&D in automatic mode to
verify correct printer operation.
For Model A00, see "How To Run
the Test and Diagnostic (T&D)
Programs" on page 161. For
Models 001, 002, or 003, see
"How To Run the Test and
Diagnostic (T&D) Programs" on
page 201.
Chapter 1. Diagnosing Problems
114