IBM 4247 Maintenance Information page 112

Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions
Power off (O) the printer. If the rear paper door does not stay open, remove the door from the printer. Remove the rear tractor
16.
from the printer. To configure the tractor for rear push mode:
v Place the tractor face down on a flat surface with the electrical connector tab on the right side, pointing toward you.
v Pull the bottom release levers toward you with your finger tips and push the movable edge of the tractor down toward the
flat surface with your thumbs (1) until the tractor locks in the fully extended position (2).
1
Rear Tractor - Push Mode (straight)
To configure the tractor for rear pull mode:
v Place the tractor face down on a flat surface with the electrical connector tab on the right side, pointing toward you.
v Pull the bottom release levers toward you with your finger tips and pull the movable edge of the tractor up away from the
flat surface with your thumbs (1) until the tractor locks in the angled position (2). The following figure shows the Rear
Tractor in Pull Mode.
Retry the failing print job. You have completed this MAP.
Are the forms sticking together or sticking to the
17.
plastic covers?
2 1
Rear Tractor - Pull Mode (bent)
Yes
2
Static electricity is present in the
forms. Contact Level 2 Support
for guidance. Go to step 18 on
page 113.
No
Go to step 18 on page 113.
Chapter 1. Diagnosing Problems
112