Connector Locations - Model 003
ASF
Operator
Stacker
Attachment
Panel
Connector
Carriage
Print Head
Motor
and Ribbon
Lift Motor
Figure 46. Connector Locations - Model 003
Network Print Server Attachment Pin 18 +5 V Jumper Location and the
Parallel Connector
The NPS Ethernet 540+ can be used without an external power supply only if +5 V dc is enabled (supplied) on
pin 18 of the printer parallel attachment connector. NPS devices (p/n 30H4082, 30H4083, 30H4055) cannot be
powered by pin 18 and always require an external +12 V ac power supply. There is no danger of damaging any
NPS or other computer devices when +5 V dc is enabled on pin 18. The new logic board you receive will have a
2 pin jumper installed on either a 2 pin or a 3 pin connector located near the parallel attachment connector.
1.
Find the 2 pin jumper and connector
Sensors
(Path, Ribbon Motion
and Carriage Home)
Tractors
AFTA
Carriage
Ribbon Driver
Fan
Motor
Power
Supply
Paper
Feed
Motor
Board
Fan
273
Chapter 4. Locations